Mesh belt conveyor is one of the commonly used transportation equipment. When using mesh belt conveyor for material transportation, there is also a certain trajectory road. Mesh belt conveyor is a material transfer machinery that continuously transports materials on a certain route, also known as a continuous conveyor, which can be divided into mesh belt type and mesh chain type. Transporters can carry out horizontal, inclined, and straight transportation, and can also form spatial transportation routes, which are usually fixed. Transporters have a large transport capacity, long transport distance, and can complete several process operations together during the transportation process, so they are widely used.
1. When using the straight guide rail of the equipment mesh belt conveyor, the device screws can be used first to fix the reference surface of the guide rail at the bottom of the mesh belt conveyor, and then the side reference surface of the guide rail can be fastened to the side equipment surface of the mesh belt conveyor machine using pliers;
2. After determining the orientation of the guide rail, a torque wrench can be used to apply a certain amount of torque and tighten and fix the screws in the corresponding order. It is also necessary to ensure that the reference surface at the bottom of the guide rail is close to the equipment surface at the bottom of the conveyor belt. It is also possible to place the straight block in the middle of two guide rails according to a certain proportion of the gap, and then select something that is measured and compared according to the standard, so that the side reference planes of the straight block and the reference side guide rail are parallel. In the future, a certain torque is selected to tighten the screws of the device. First, fix one slider of the driven side guide rail and two sliders of the reference side guide rail on the channel of the transport equipment. Then, fix the driven side guide rail and the other slider separately on the transport machine, and use the reference side guide rail as the precise fixed channel;
3. We also need to start from one end of the straight guide rail to check the appearance of the rolling resistance of the driven side straight guide rail, and wait until it is fully determined before tightening the screws in the future.

This article is from: http://www.zs-chsb.com/