1. What is the reason for the abrasion of the upper rubber surface on the conveyor belt, which is not wear-resistant and has been used for less than a month?
The non wear resistance of conveyor belts indicates that the high wear of conveyor belts is caused by the excessive use of recycled rubber, styrene butadiene rubber, and natural rubber in the production process of conveyor belts. In other words, the high rubber content of recycled rubber and the low rubber content of styrene butadiene rubber and natural rubber in the rubber material ratio of the conveyor belt cover. Some conveyor belt manufacturers, in order to save production costs, use a large amount of recycled rubber in the production process of conveyor belts, but unfortunately use less styrene butadiene rubber and natural rubber, resulting in high wear and non wear of conveyor belts.
2. What is the reason for the delamination problem on the conveyor belt.
The problem of delamination on the conveyor belt after 2-5 days of use is a quality issue, and the important issue is the bonding of the fabric. The conveyor belt uses fabric from Wuxi Taiji, which has good bonding and high load-bearing capacity.
3. What causes the conveyor belt to bubble after a period of time.
Bubbling on the conveyor belt is a quality issue, and there are many reasons that can cause blistering on the conveyor belt, including the following important points
1. The raw materials used in the production of conveyor belts (including butadiene styrene, carbon black, natural rubber, etc.) have a high moisture content, which leads to foaming of the conveyor belts produced. Each batch of raw materials brought into the factory by the conveyor belt must undergo rigorous testing before entering the factory.
2. The second reason is that the formula of the conveyor belt is unfair. The conveyor belt adopts Zhongce skills, and the engineer has 15 years of work experience and proficient skills.
3. The third reason is that the purchased fabric has a high moisture content, and the conveyor belt accepts fabric from Wuxi Taiji. Moreover, each batch of fabric entering the factory undergoes strict acceptance procedures before it can be put into production.


This article is from: www.zs-chsb.com