2024-07-19 347
1. What is the reason for the abrasion of the upper rubber surface on the conveyor belt, which is not wear-resistant and has been used for less than a month?The non wear resistance of conveyor belts
2024-07-19 353
The use of mechatronics material transportation equipment began in China in the early 1990s, and after more than 20 years of development, it has now become a widely used transportation equipment in pr
2024-07-19 381
1. Prevent the conveyor belt from being blocked by racks, pillars, or block materials, and prevent it from being damaged or torn. If the conveyor belt deviates during pregnancy, the problem should be
2024-07-19 370
Due to the continuity of forging production, the transportation of the system cannot be continuous, therefore, there is a high demand for the operation and maintenance of the entire system transportat
2024-07-18 359
Based on the central line where the adhesive tape runs, all rollers, tapes, brackets, rollers, etc. are wrapped on the central line. The degree of deviation (or inclination) of the conveyor belt is sm
2024-07-18 354
Production line work causes chaos in the art marketToday, in various occasions with a bit of artistic atmosphere, we often receive some people handing over hand sticks. On this small card, there will
2024-07-18 375
Due to the accelerated pace of modern life, consumers have an increasing demand for leisure food and fast-paced food. In the future, there will be an increasing demand for intelligent and proactive pa
2024-07-18 345
Performance characteristicsThe feeding spiral has a unique stable flow layout, and the material powder sinks evenly across the entire feeding inlet section, making it less prone to arching and flushin
2024-07-17 378
Europe's sales have been declining continuously for the past six years, and this year it has achieved growth In recent years, the European car market has had a difficult time, with sales continui
2024-07-17 362
1. The screw conveyor should be started without load, that is, when there is no material inside the casing, it can only be fed to the screw conveyor after starting.During the initial feeding of the s